The primary gear train on my 1941 South Bend lathe makes a lot of noise.

The primary gear train on my 1941 South Bend lathe makes a lot of noise. I believe the biggest culprit is the sliding gear, but the spindle gear is also very worn. I can’t find an exact replacement, but found something that is the correct tooth count, diametral pitch, pressure angle and diameter. But, it’s not as thick (1/2″ vs 11/16″) and has a smaller bore at .750″ and I need 1.437″. So I decide to modify the new gear to see if it helps with the noise. Check the link in my bio for a video of how I modified the bottom gear to replace the one shown on the top.⁠
.⁠
.⁠
.⁠
.⁠
.⁠
.⁠

Instagram Source

Feel free to leave a comment or question

This site uses Akismet to reduce spam. Learn how your comment data is processed.