I have been wanting one of these for years! Can’t wait to build it and start putting it to use. .
.
.
Starting to get more done to the shop again.
Starting to get more done to the shop again. Ran a couple 220v circuits for each of the welders plus a 110v circuit for some much needed outlets. Changed my plans a bit and swapped the welders to the east wall so the runs are shorter.
.
.
.
Decided to raise the workbench up to a total of 40”
Decided to raise the workbench up to a total of 40”. Seemed like it was going to be tall, but I really like it. It’ll match up well with the soon to be ordered @weldtables welding table.
.
.
.
Got this old Sears/Devilbiss air compressor restored.
Got this old Sears/Devilbiss air compressor restored. Replaced all the gaskets and piston rings. New controller and regulator valve. Fresh coat of paint. Super quiet compared to my other compressor. And this one can hold 7.4cfm@125psi.
.
.
.
Trying out some 7018 on the new welder.
Trying out some 7018 on the new welder. Haven’t run any SMAW for 2 1/2 years and that was only once or twice. This machine makes it seem too easy.
.
.
.
.
.
Making lots of progress on the workshop.
Making lots of progress on the workshop. Concrete is set and cleaned and even managed to get the man doors and the overhead door installed. .
.
.
.
Almost there.
Almost there. A little more troweling and it will be time to sit back and watch it cure. Hopefully the heater will do what it needs to and keep the shop above freezing for the next couple of nights. .
.
.
.
